Service graphs
|
|
|
|
Graph Information
This graph shows the value of all S.M.A.R.T attributes of drive sdb (ST8000NE001-2M7101). smartctl_exit_status is the return value of smartctl. A non-zero return value indicates an error, a potential error, or a fault on the drive.
Note: This service is in WARNING state because one of the values reported is outside the allowed range. Please see further down for information about the ranges and the graph for the values.
| Field | Internal name | Type | Warn | Crit | Info |
|---|---|---|---|---|---|
| Raw_Read_Error_Rate | Raw_Read_Error_Rate | gauge | 044: | ||
| Spin_Up_Time | Spin_Up_Time | gauge | 000: | ||
| Start_Stop_Count | Start_Stop_Count | gauge | 020: | ||
| Reallocated_Sector_Ct | Reallocated_Sector_Ct | gauge | 010: | ||
| Seek_Error_Rate | Seek_Error_Rate | gauge | 045: | ||
| Power_On_Hours | Power_On_Hours | gauge | 000: | ||
| Spin_Retry_Count | Spin_Retry_Count | gauge | 097: | ||
| Power_Cycle_Count | Power_Cycle_Count | gauge | 020: | ||
| Unknown_Attribute | Unknown_Attribute | gauge | 050: | ||
| Reported_Uncorrect | Reported_Uncorrect | gauge | 000: | ||
| Command_Timeout | Command_Timeout | gauge | 000: | ||
| Airflow_Temperature_Cel | Airflow_Temperature_Cel | gauge | 040: | ||
| Power_Off_Retract_Count | Power_Off_Retract_Count | gauge | 000: | ||
| Load_Cycle_Count | Load_Cycle_Count | gauge | 000: | ||
| Temperature_Celsius | Temperature_Celsius | gauge | 000: | ||
| Hardware_ECC_Recovered | Hardware_ECC_Recovered | gauge | 000: | ||
| Current_Pending_Sector | Current_Pending_Sector | gauge | 000: | ||
| Offline_Uncorrectable | Offline_Uncorrectable | gauge | 000: | ||
| UDMA_CRC_Error_Count | UDMA_CRC_Error_Count | gauge | 000: | ||
| Head_Flying_Hours | Head_Flying_Hours | gauge | 000: | ||
| Total_LBAs_Written | Total_LBAs_Written | gauge | 000: | ||
| Total_LBAs_Read | Total_LBAs_Read | gauge | 000: | ||
| smartctl_exit_status | smartctl_exit_status | gauge | 1 |